Stop: Difference between revisions
Jump to navigation
Jump to search
(Created from old MeasurementClass page and added introduction and structure.) |
m (Added Categories.) |
||
| Line 8: | Line 8: | ||
This [[Measurement Classes|Measurement Class]] can be used to reduce stress on a device. | This [[Measurement Classes|Measurement Class]] can be used to reduce stress on a device. | ||
Furthermore, a stop time can be used to vary the time between consecutive parameter calls. | Furthermore, a stop time can be used to vary the time between consecutive parameter calls. | ||
[[Category:Measurement Classes]] | |||
[[Category:Pseudo Measurement Classes]] | |||
Revision as of 17:23, 29 September 2017
Stop is a Pseudo Measurement Class used for specific waiting tasks in the measurement.
Usage
Double-click Stop in the sequencer tab to edit the time. SweepMe! waits the given time in seconds after changing the applied parameters of each device to the idle value if given.
Applications
This Measurement Class can be used to reduce stress on a device. Furthermore, a stop time can be used to vary the time between consecutive parameter calls.