Stop

From SweepMe! Wiki
Jump to navigation Jump to search

The Stop module no longer exists. It was removed in SweepMe! 1.5.5.33.

The Stop module set all devices of a branch to their idle value for a given time after each measurement point, e.g. to remove stress from a sample before the next point was measured.

Similar procedures can be created with the sequencer:

  • Use a Delay module to wait for a given time.
  • Use a SweepBox or the module ReadValues to alternate between a measurement value and a rest value, e.g. a voltage of 0 V.

To stop a run automatically when a condition is fulfilled, use the Condition module with the action "stop".