Signout()
Jump to navigation
Jump to search
The function 'signout' is the counterpart of signin(). It is called when a module has finished its parameter variation, i.e. after the measurement point with its last sweep value. It is also called if the run is stopped by the user or by an error, for all modules that are signed in at that time.
If a module higher up in the sequencer then moves on to its next sweep value, the module signs in again and signin() is called. Thus, 'signin' and 'signout' frame each complete parameter variation of a module. Modules lower in the sequencer sign out before the modules above them.
Use 'signout' for actions that should happen after each parameter variation, e.g. to stop a data stream that was started in signin().